Anycubic PETG Filament – Black (1.75mm, 1kg)
Tough, impact-resistant PETG | Water, weather and chemical resistant | Handles more heat than PLA | ACE compatible | Works with any 1.75mm FDM printer
Tough, practical parts that last. Anycubic PETG combines PLA’s ease of printing with much of ABS’s toughness. It’s the go-to filament for functional parts, outdoor prints and anything that needs to survive real-world use.
Takes a knock. PETG has roughly double the impact strength of PLA and flexes slightly before it breaks, so parts are much less likely to crack or shatter. It’s ideal for brackets, clips, mounts, enclosures, tool holders and replacement parts.
Built for real-world conditions. It resists water, weather and many common chemicals, and handles more heat than PLA: it softens at about 70°C, compared with around 54°C for PLA. That makes it a strong choice for garden fittings, car interior parts, bathroom and kitchen accessories, and outdoor use.
Strong layers. It has good layer bonding (31 MPa in Z, higher than any of the PLAs), so functional parts stay solid in every direction.
Deep black finish. Clean, glossy black gives functional parts a finished, professional look.
Key features
- Tough and impact-resistant, much less brittle than PLA
- Water, weather and chemical resistant
- Higher heat resistance than PLA (softens at about 70°C)
- Strong layer bonding
- Deep black finish
- Works with any 1.75mm FDM printer (0.2mm nozzle or larger)
- Anycubic ACE compatible, with automatic settings on compatible printers
- Reusable spool
Specifications
- Material: PETG
- Colour: black
- Diameter: 1.75mm
- Net weight: 1kg
- Nozzle size: 0.2mm or larger
- Printing temperature: 230–250°C
- Bed temperature: 60–70°C
- Recommended print speed: 50–250mm/s
- Max flow rate: 12mm³/s
- Drying: required before use, 55–65°C for 6–8 hours
- Density: 1.23 g/cm³
- Melt index: 25 ± 3 g/10 min (250°C / 2.16kg)
- Vicat softening temperature: 72°C
- Heat deflection temperature: 69°C (0.45 MPa)
- Tensile strength: 52 ± 1 MPa (X-Y), 31 ± 3 MPa (Z)
- Young’s modulus: 1,850 ± 100 MPa
- Elongation at break: 13 ± 1%
- Flexural strength: 80 ± 2 MPa
- Flexural modulus: 2,000 ± 50 MPa
- Izod impact strength (X-Y): 45 ± 2 kJ/m²
- ACE compatible: yes
- Spool identification: supported
- Reusable spool: yes
Tips for best results
-
Dry before printing, at 55–65°C for 6–8 hours. PETG absorbs moisture, and damp PETG strings and bubbles.
-
Use glue stick or a release agent on smooth PEI beds. PETG can stick so well it pulls chunks off the surface.
- Expect a little stringing, which is normal for PETG. Tune retraction or use a quick pass with a heat gun.
- Store it sealed with desiccant between prints.
What’s in the box
- 1 × Anycubic PETG Filament – Black (1kg spool)
