Anycubic PLA Galaxy Filament – Galaxy Blue (1.75mm, 1kg)
Shimmering starry finish | Colour shifts with the light | Hides layer lines | Prints with standard PLA settings | ACE compatible
Prints that sparkle like the night sky. Anycubic PLA Galaxy is packed with fine sparkle particles that give prints a shimmering, starry finish. The colour shifts as light hits it from different angles, turning decorative models, figurines and art pieces into eye-catching display pieces.
A galaxy in every print. Deep midnight blue filled with tiny sparkles gives a rich, cosmic look that changes as you move around it. It’s ideal for space and sci-fi models, figurines, ornaments, vases and gifts.
Hides layer lines. The sparkle effect breaks up the surface, so layer lines are much harder to see and prints look polished with no painting needed.
Sparkle that stays put. The sparkle is bonded into the filament, so it won’t rub off or shed from finished prints.
Easy to print. It uses standard PLA settings, so there’s nothing special to set up, and it’s great for beginners. On compatible Anycubic printers, spool identification sets the print settings for you automatically.
Key features
- Shimmering starry finish with colour that shifts in the light
- Sparkle hides layer lines
- Sparkle is bonded in and won’t shed
- Standard PLA print settings
- Automatic settings on compatible Anycubic printers
- Anycubic ACE compatible
- Reusable spool
Specifications
-
Material: PLA (galaxy sparkle)
-
Colour: galaxy blue
-
Diameter: 1.75mm
-
Net weight: 1kg
-
Nozzle size: 0.4mm or larger
-
Printing temperature: 200–230°C
-
Bed temperature: 60–65°C
-
Recommended print speed: 40–260mm/s
-
Max flow rate: 12mm³/s
-
Drying: recommended, 55–60°C for 6–8 hours
-
Density: 1.23 g/cm³
-
Melt index: 5.85 g/10 min (190°C / 2.16kg)
-
Melting point: 156°C
-
Vicat softening temperature: 56°C
-
Heat deflection temperature: 53°C (0.45 MPa)
-
Tensile strength (Z): 36 ± 1 MPa
-
Young’s modulus: 3,500 ± 300 MPa
-
Elongation at break: 12 ± 2%
-
Flexural strength: 95 ± 2 MPa
-
Flexural modulus: 3,500 ± 200 MPa
-
Izod impact strength (X-Y): 25 ± 3 kJ/m²
-
ACE compatible: yes
-
Spool identification: supported
-
Reusable spool: yes
Tips for best results
-
Use a 0.4mm or larger nozzle. The sparkle particles can clog smaller nozzles.
-
Dry the spool at 55–60°C for 6–8 hours if it’s been open for a while.
-
For the best shimmer, print in good light and try slightly slower outer walls.
-
PLA softens at around 53°C, so keep prints out of hot cars and direct sun.
What’s in the box
-
1 × Anycubic PLA Galaxy Filament – Galaxy Blue (1kg spool)
